Wiring is done but there is a draw on the battery
#1
V8 Miata Fan
Thread Starter
Wiring is done but there is a draw on the battery
i have my wiring complete and the car runs but something is draining the battery quite fast. With a volt meter on it you can watch the volts drop (car is not on when this happens).
i have the engine ground hooked up and the ground at the rear of the car.
The only thing was that I had the alternator wired wrong and it wasn’t charging but that is fixed and tested.
The only other thing I can think of is. Pin 17 for the check engine light is supposed to be tan. Mine is yellow with black. I can not find a tan wire. The mustang manual mentions a yellow with black wire for pin 17 but also says pin 17 is tan. I hooked up the yellow with black from pin 17. I have no check engine light.
Any help would be appreciated. Thanks
i have the engine ground hooked up and the ground at the rear of the car.
The only thing was that I had the alternator wired wrong and it wasn’t charging but that is fixed and tested.
The only other thing I can think of is. Pin 17 for the check engine light is supposed to be tan. Mine is yellow with black. I can not find a tan wire. The mustang manual mentions a yellow with black wire for pin 17 but also says pin 17 is tan. I hooked up the yellow with black from pin 17. I have no check engine light.
Any help would be appreciated. Thanks
#3
V8 Miata Zealot
Try this:
https://www.wikihow.com/Find-a-Parasitic-Battery-Drain
Since you said that you had an issue with the alternator, you may want to disconnect that first.
https://www.wikihow.com/Find-a-Parasitic-Battery-Drain
Since you said that you had an issue with the alternator, you may want to disconnect that first.
#4
V8 Miata Fan
Thread Starter
The alternator has been fixed and is charging at 14 volts. I know the battery is bad. I just didn’t think it would drain while you watched it on the meter.
#5
V8 Miata Fan
Thread Starter
Turns out the battery was bad after all.
Pin 17 for the check engine light is supposed to be tan. Mine is yellow with black. I can not find a tan wire. The mustang manual mentions a yellow with black wire for pin 17 but also says pin 17 is tan. I hooked up the yellow with black from pin 17. I have no check engine light.
Any help would be appreciated. Thanks
Pin 17 for the check engine light is supposed to be tan. Mine is yellow with black. I can not find a tan wire. The mustang manual mentions a yellow with black wire for pin 17 but also says pin 17 is tan. I hooked up the yellow with black from pin 17. I have no check engine light.
Any help would be appreciated. Thanks
#6
V8 Miata Zealot
If you are using a computer from a 1988 Mustang, that year model does not display a check engine light. That feature was not introduced until 1989, when they also introduced the mass airflow sensor on all Mustangs. Only California emission equipped Mustangs had a MAF sensor in 1988.
#7
V8 Miata Fan
Thread Starter
Thanks. I did not know that about the check engine light. I did about the mass air.
So if I don’t have a check engine light how will I get codes?
So if I don’t have a check engine light how will I get codes?
Thread
Thread Starter
Forum
Replies
Last Post
RYNO
V8 Miata Wiring, Electrical, and ECUs
6
03-29-2020 07:22 PM
wallyman
V8 Miata Wiring, Electrical, and ECUs
7
08-08-2016 12:39 PM
qurtrn10
Ford V8 Discussion
13
02-10-2015 07:30 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)