v8 Miata Forum - Home of the v8 Miata Conversion

v8 Miata Forum - Home of the v8 Miata Conversion (https://www.v8miata.net/)
-   V8 Miata Wiring, Electrical, and ECUs (https://www.v8miata.net/v8-miata-wiring-electrical-ecus-13/)
-   -   Wiring is done but there is a draw on the battery (https://www.v8miata.net/v8-miata-wiring-electrical-ecus-13/wiring-done-but-there-draw-battery-3373/)

baad88 09-18-2018 08:13 PM

Wiring is done but there is a draw on the battery
 
i have my wiring complete and the car runs but something is draining the battery quite fast. With a volt meter on it you can watch the volts drop (car is not on when this happens).
i have the engine ground hooked up and the ground at the rear of the car.
The only thing was that I had the alternator wired wrong and it wasn’t charging but that is fixed and tested.
The only other thing I can think of is. Pin 17 for the check engine light is supposed to be tan. Mine is yellow with black. I can not find a tan wire. The mustang manual mentions a yellow with black wire for pin 17 but also says pin 17 is tan. I hooked up the yellow with black from pin 17. I have no check engine light.
Any help would be appreciated. Thanks

baad88 09-18-2018 08:20 PM

Also the battery is old. Could that be the problem?

tbone heller 09-19-2018 02:11 PM

Try this:
https://www.wikihow.com/Find-a-Parasitic-Battery-Drain

Since you said that you had an issue with the alternator, you may want to disconnect that first.

baad88 09-19-2018 04:08 PM

The alternator has been fixed and is charging at 14 volts. I know the battery is bad. I just didn’t think it would drain while you watched it on the meter.

baad88 09-22-2018 09:47 PM

Turns out the battery was bad after all.

Pin 17 for the check engine light is supposed to be tan. Mine is yellow with black. I can not find a tan wire. The mustang manual mentions a yellow with black wire for pin 17 but also says pin 17 is tan. I hooked up the yellow with black from pin 17. I have no check engine light.
Any help would be appreciated. Thanks

tbone heller 09-24-2018 10:52 AM

If you are using a computer from a 1988 Mustang, that year model does not display a check engine light. That feature was not introduced until 1989, when they also introduced the mass airflow sensor on all Mustangs. Only California emission equipped Mustangs had a MAF sensor in 1988.

baad88 09-24-2018 06:38 PM

Thanks. I did not know that about the check engine light. I did about the mass air.
So if I don’t have a check engine light how will I get codes?

tbone heller 09-25-2018 01:53 PM


Originally Posted by baad88 (Post 25231)

So if I don’t have a check engine light how will I get codes?

With a code reader for EEC IV. Old school!

tbone heller 09-25-2018 02:23 PM



All times are GMT -5. The time now is 12:34 PM.


© 2024 MH Sub I, LLC dba Internet Brands