Ignition wiring question
#1
Ignition wiring question
I have a 1993 miata that I am putting the ford 5.0 motor in out of a 91 mustang. I am carbeurating the motor in hopes that it will lessen the amount of wiring needed, and because I have completely rebuilt a 1970 camaro from the ground up and I am familiar with carbs and not so much with fuel injection...My question is can I use the ignition wiring from the miata? That is, can i use the same wires that ran to the original mazda starter and run them to the starter on the 5.0?
#3
Ok cool. Now what other wiring harnesses or other wires can I remove from the engine bay? I am trying to keep it all clean looking and do not want random wires obviously. But can I remove the PCM or ECU? Since I am doing a carbeurated motor and the vehicle will not be sending or recieving any information from sensors on the motor or trans.
#4
V8 Miata Habitué
I'm using a Jetta MK4 fuse box and putting it on the passenger side. That remove the big fuse box in the engine bay. Hope that help.
That clear a lot of wire for sure...
That clear a lot of wire for sure...
Thread
Thread Starter
Forum
Replies
Last Post
Sunshine Guy
Bargain Hunter's Bulletin Board
3
06-18-2015 06:33 PM
MRM331
V8 Miata Wiring, Electrical, and ECUs
21
10-08-2014 04:51 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)