Power steering question
#1
V8 Miata Noob
Thread Starter
Power steering question
Hey all! I had a quick question for anyone that may have done this before on a Miata or any other car really. I am putting a Ford 4.0 into an NA Miata and the line lines up perfectly except for one thing.. The line on the high pressure side coming from the pump is a female end.. and so is the outlet on the pump. I did a bit of googling and searching but couldnt find much.
SO my question is could I get a male to male adapter that would screw into the pump and the high pressure line or would this not work? My worry is that since the factory lines are flared ends that a screw in insert would not seal properly and I know these lines are under a load of pressure.
My other question is how would I find the thread pitch of the line? Is it AN, NTP, Metric, Standard ect.
Thanks!
Alex
SO my question is could I get a male to male adapter that would screw into the pump and the high pressure line or would this not work? My worry is that since the factory lines are flared ends that a screw in insert would not seal properly and I know these lines are under a load of pressure.
My other question is how would I find the thread pitch of the line? Is it AN, NTP, Metric, Standard ect.
Thanks!
Alex
#2
FWIW, on my SN95 5.0, it was super easy to get a new Ford line from the pump, then cut and re-flare it on the rack end using the Miata nut. Added a small thin brass washer for extra insurance and it has worked perfectly for 6 years, no leaks.
#3
V8 Miata Noob
Thread Starter
Appreciate the response! I ordered a male to male adapter so if that doesn't work I'll look at getting an explorer ps line and swapping ends to reflare!
#4
V8 Miata Participant
I found a male to male brass flare at Home Depot as a "test" adapter of all places that threaded into each end nicely and literally no issues. Two years use and a daily driver.
The following users liked this post:
charchri4 (06-16-2016)
Thread
Thread Starter
Forum
Replies
Last Post
rey
V8 Miata Safety, Legal, & Emissions
11
03-17-2014 02:14 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)