Turbo Ls1 na Miata build
#26
Hood clearance issues are the least of my worry at this point. I plan on going with a blow through carburetor (which will eliminate my horizontal issues of needing a intercooler since carbs run significantly cooler), however I will need additional vertical space regardless.
Do you still have your ls1 oil pan setup? Ide be interested in getting it off of you if so. I am going to shoot you my cell number so we can bounce ideas off one another more readily.
Do you still have your ls1 oil pan setup? Ide be interested in getting it off of you if so. I am going to shoot you my cell number so we can bounce ideas off one another more readily.
#27
V8 Miata Fan
Thread Starter
fender
as far as the fender... only the top half is wide, the bottom will just curve into the tire well...
You can see by the door area, i have the fender popping out about an inch and a half, why? I saw it on an Rx7 and liked it
You can see by the door area, i have the fender popping out about an inch and a half, why? I saw it on an Rx7 and liked it
The following users liked this post:
97miatam (02-09-2016)
#29
V8 Miata Follower
So wait a second here. So you mean to tell me you got the LS1 in there with only cutting up the passenger side of the subframe. And had steering rack clearance with the holley 302-2???
Would you estimate the engine sits a lot higher than the V8R subframe?
Is the reason you didnt have to cut up the driver side because you dont need the room for the header?
Would you estimate the engine sits a lot higher than the V8R subframe?
Is the reason you didnt have to cut up the driver side because you dont need the room for the header?
Thread
Thread Starter
Forum
Replies
Last Post
Hbwiggins
General Motors V8 Miata Build Threads
113
09-24-2015 08:13 PM
miatainthe10s
General Motors V8 Miata Build Threads
35
06-21-2015 06:10 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)