clutch hydraulics: issues with GM hydraulic throw out bearing
#1
V8 Miata Noob
Thread Starter
Join Date: Nov 2017
Location: albemarle north carolina
Posts: 13
Likes: 0
Received 0 Likes
on
0 Posts
clutch hydraulics: issues with GM hydraulic throw out bearing
So, i think we have a problem, Huston.
Setup is a 1999 miata clutch master with a gm slave from a t56. Its one of the hydraulic throwout bearing type slaves.
Braided line between the two.
We're reasonably certain that the hydraulics are good, and the slave is spaced properly.
Im thinking that the stock clutch master is the issue. Flying miata uses a 7/8 v8 roadster clutch master kit in their ls swap cars, which this shares the slave with.
Which means that i need to find a 7/8 Clutch master, and it fixes it, right?
Is there anything else to look at/check?
Clutch master is adjusted now for maximum stroke, and ive run about a quart of fluid through via 2 man bleed, gravity bleed, and reverse bleeding....
Setup is a 1999 miata clutch master with a gm slave from a t56. Its one of the hydraulic throwout bearing type slaves.
Braided line between the two.
We're reasonably certain that the hydraulics are good, and the slave is spaced properly.
Im thinking that the stock clutch master is the issue. Flying miata uses a 7/8 v8 roadster clutch master kit in their ls swap cars, which this shares the slave with.
Which means that i need to find a 7/8 Clutch master, and it fixes it, right?
Is there anything else to look at/check?
Clutch master is adjusted now for maximum stroke, and ive run about a quart of fluid through via 2 man bleed, gravity bleed, and reverse bleeding....
Thread
Thread Starter
Forum
Replies
Last Post
jonbon88
V8 Miata Drivetrains
7
03-29-2020 09:24 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)