installed two new Timken bearings,on the same side,beat in new bearing,and hub,put wheel back on,and there is play in the wheel bearing,other side is tight,running out of ideas

 

Did you press the bearing in, or pound it in? Is the axle nut tight?

 

I pounded bearing in

 

axle nut is tight

 

There is only one wheel bearing per side, correct? The inner race is two pieces but it is only one bearing. You may want to remove the hub and install another new bearing.

 

What axles are you using?

 

You can't do that. You easily damage the bearing, or get it cocked in the spindle.

Press the bearing out, and inspect the spindle very carefully. If there's any significant damage, toss the spindle and start over.