Engine Rebuild
#1
V8 Miata Enthusiast
Thread Starter
Join Date: Oct 2013
Location: Colorado Springs, CO
Posts: 421
Likes: 0
Received 33 Likes
on
27 Posts
Engine Rebuild
Time for an engine rebuild. I installed the short block untouched with 50,000 miles on it. Then beat on it at the race track for 3 years. It was starting to leak and burn oil. Best to do it now, rather than in the middle of the season.
Exocet V8 Engine Rebuild
Exocet V8 Engine Rebuild
#2
Time for an engine rebuild. I installed the short block untouched with 50,000 miles on it. Then beat on it at the race track for 3 years. It was starting to leak and burn oil. Best to do it now, rather than in the middle of the season.
Exocet V8 Engine Rebuild
Exocet V8 Engine Rebuild
Added in edit; it was late and I was tired. Failed to click the link last night. What a great write-up on the engine freshening up. Well Done Sir!
Good Luck
RonR
Last edited by 5.0MX5; 02-25-2019 at 10:47 AM.
#3
V8 Miata Enthusiast
Thread Starter
Join Date: Oct 2013
Location: Colorado Springs, CO
Posts: 421
Likes: 0
Received 33 Likes
on
27 Posts
"finished" the rebuild and install a couple of weeks ago. Picked it up from the dyno tuner this morning.
The short block was used when I installed it three years go. The heads were rebuilt before installation. Didn't look too bad this year.
Looked a lot better after re-assembly.
I used the new rocker arms from the LS6 Store.
During disassembly, I noticed that some of the cover and oil pan bolts were a little lose. Probably increasing the oil leaks. I used safety wire this time.
The short block was used when I installed it three years go. The heads were rebuilt before installation. Didn't look too bad this year.
Looked a lot better after re-assembly.
I used the new rocker arms from the LS6 Store.
During disassembly, I noticed that some of the cover and oil pan bolts were a little lose. Probably increasing the oil leaks. I used safety wire this time.
#4
V8 Miata Enthusiast
Thread Starter
Join Date: Oct 2013
Location: Colorado Springs, CO
Posts: 421
Likes: 0
Received 33 Likes
on
27 Posts
I changed the cam. Mostly because I'm not smart enough to leave well enough alone.
And the intake. I chose the Edelbrock because it had a lower profile. It just barely clears the hood. I had to cut and weld the throttle bracket to fit right.
Gained a little HP, lost a little torque.
Tune from 2016
I have some details to attend to (like new front fenders). First race is 13 April. Should be ready in time.
And the intake. I chose the Edelbrock because it had a lower profile. It just barely clears the hood. I had to cut and weld the throttle bracket to fit right.
Gained a little HP, lost a little torque.
Tune from 2016
I have some details to attend to (like new front fenders). First race is 13 April. Should be ready in time.
Thread
Thread Starter
Forum
Replies
Last Post
rharris19
V8 Miata Wiring, Electrical, and ECUs
4
01-21-2010 06:51 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)