My hood DIY
03-29-2015, 09:19 AM
#1
V8 Miata Habitué
Thread Starter
My hood DIY
Hood are hard to hand made so your better to start with a existing shape. In my case i use a corvette 76 Hood and cut it.
Be sure all your part respect your line. And you must bold it to the Hood.
Because your next step is to cut all that your can and begin to laminate your exterior side with fiberglass. If you don't do it you will not be able to keep your nice curve.
Now it's time to work on the Inside. Cut all the aluminum you need to make your engine fit, but not more. Keed all the Hood frame you can, but at the same time remove all loose Hood (See left part of the picture).
After that, remove all your bolt and put a first layer of fiberglass. After 1 hour finish with one layer of rooving.
Next day turn your Hood and cut the uncut part. In my case i cut the back of the cowl and add the cowl back trim.
Once all is glue together apply one good layer of fiberglass putty and one light putty.
It's time to uses your sanding bloc and a lot of time.
Don't be afraid to prime your Hood to see where you are.
After that your ready to paint
Be sure all your part respect your line. And you must bold it to the Hood.
Because your next step is to cut all that your can and begin to laminate your exterior side with fiberglass. If you don't do it you will not be able to keep your nice curve.
Now it's time to work on the Inside. Cut all the aluminum you need to make your engine fit, but not more. Keed all the Hood frame you can, but at the same time remove all loose Hood (See left part of the picture).
After that, remove all your bolt and put a first layer of fiberglass. After 1 hour finish with one layer of rooving.
Next day turn your Hood and cut the uncut part. In my case i cut the back of the cowl and add the cowl back trim.
Once all is glue together apply one good layer of fiberglass putty and one light putty.
It's time to uses your sanding bloc and a lot of time.
Don't be afraid to prime your Hood to see where you are.
After that your ready to paint
03-29-2015, 06:25 PM
#3
V8 Miata Habitué
Thread Starter
The car is in my paint booth for wet sand and polishing.
I have done that kind of metal fibreglass a lot of time and we see -35c during winter.
For the picture i will take some when i have finish polishing. And take the headlight at the same time
I have done that kind of metal fibreglass a lot of time and we see -35c during winter.
For the picture i will take some when i have finish polishing. And take the headlight at the same time
05-14-2015, 11:02 AM
#6
V8 Miata Follower
Du très beau travail!
I'd love to make something like this... I just painted a stick-on pvc hood scoop for now, but this would be an awesome upgrade! thanks for posting!
I'd love to make something like this... I just painted a stick-on pvc hood scoop for now, but this would be an awesome upgrade! thanks for posting!
The following users liked this post:
charchri4 (05-14-2015)
03-24-2018, 07:12 PM
#11
V8 Miata Follower
Resin?
Hi sebz, I'm looking to make myself one of these hoods this summer .. I am experienced in bodywork but not fiberglass... Everything I read says fiberglass doesn't stick to aluminum.. how did you get it to stick? Special resin?
Thread
Thread Starter
Forum
Replies
Last Post
Jack Sprat
Ford V8 Miata Build Threads
215
10-22-2018 04:48 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
